Inspection rules for rubber parts for automobiles

[袁春凤 (Tiffany)]

Inspection rules for rubber parts for automobiles

1.rubber hardness

Test method of indentation hardness based on GBT531.1-2008 rubber pocket hardness tester

contents and requirements

Instruments and equipment: Shahr hardness tester (type A, D)

Environmental conditions: the laboratory temperature is 23 C + + 2 C, the relative humidity is 60%~70231

Test method: the specimen thickness is at least 6mm. If the thickness of the sample is less than 6 mm, it can be stacked with no more than 3 layers of smooth, parallel samples with each layer thickness not less than 2 mm. The specimen must have enough area to make the needle and specimen contact position at least 12mm from the edge.

Place the specimen on a solid plane, hold the hardness tester, press the pin at least mm from the edge of the specimen, press the pin smoothly on the specimen, and read it within 3 seconds after the full contact of the pin with the specimen.

Results: the hardness values were measured 5 times at different locations of 6mm, and the median was taken.

Feilong Jiangli will update the more inspection rules for automobile rubber parts